Diva RDW 9RN Manuel d'installation

21·CAREFULLY FOLLOW THE INSTRUCTIONS BELOW TO ENSURE THE IDEAL OPERATION OFTHE AIR CONDITIONER.·HANDLE THE UNIT WITH CARE AND NEVER TURN THE AIR CONDI

30The pipe protection grills must be applied outside the wall where the unit is installed.Cut part of the right grill (looking at the unit from the re

INSTALLATION DIMENSIONS (SEEN FROM INSIDE) N.B.: DIMENSIONS FOR THE CONDENSATE DRAINAGE AND VENTILATION HOLES!THE OUTLINE REGARDS THE UNIT'S REAL

32CEILING INSTALLATIONThis type of installation is used when the unit cannot be adequately fastened or recessed into a wall or whenever the wall is ma

33fig. 3 fig. 4Remove the eyelets and replace themwith threaded bars whenever necessary.N.B. Correct installation requires that the unit must be faste

34CEILING INSTALLATION ASSEMBLY PROCEDURE - WALL1. Position the supplied paper template on the wall and using a pencil mark the position of the two ho

CEILING INSTALLATION ASSEMBLY PROCEDURE - GLASS1. Position the paper template supplied on the glass and with a pencil mark the positions of the two ho

361a. Condensate drainage preparationWhenever the unit must be removed, make sure to first drain the condensate collection tray to avoid annoyingwate

AIR SUCTIONAIR EXPULSIONCONDENSATEDRAINAGE2a. Installation of the unitIMPORTANT: Handle the unit with care paying extra attention to avoid damaging or

38AUXILIARY CONDENSATE DRAINAGERemove the plug from the condensate drainage nozzle positioned atthe lower right as shown in Figure 1, making sure to a

6. POWER SUPPLY9. OPTIONAL KITSCEILING INSTALLATION KIT (Code: 231065)Containing 2 brackets with eyelets and screws for the fastening of threaded bars

22D. We recommend installing the unit at least 200 cm above the floor in order to permit complete and correct air distribution inthe room. A distance

40Cod.: 000495NOTE

23We provide an installation diagram below that summarises all the information found in the respective chapters that explain thevarious types of insta

24ASSEMBLY PROCEDURE1. Position the supplied paper template on the wall and using a pencil mark the positions of the two holes to be drilled and the p

257. Condensate drain preparationWhenever the unit must be removed, make sure to first drain the condensate collection tray to avoid annoyingwater spi

268. Installation of the unitIMPORTANT: Handle the unit with care paying extra attention to avoid damaging or scratching the parts of the unit that wi

27ASSEMBLY PROCEDURE1. Position the paper template supplied on the wall and using a pencil markthe position of the opening to be made in the wall at a

287. condensate drain preparationWhenever the unit must be removed, make sure to first drain the condensate collection tray to avoid annoyingwater spi

298. Installation of the unitIMPORTANT: Handle the unit with care paying extra attention to avoid damaging or scratching the parts of the unit that wi